Lincoln Aviator: Wheels and Tires / Technical Specifications
Wheel Lug Nut Torque Specifications
WARNING: When you install a wheel, always remove any corrosion, dirt or
foreign materials present on the mounting surfaces of the
wheel or the surface of the wheel hub, brake drum or brake disc that contacts
the wheel. Make sure to secure any fasteners that attach
the rotor to the hub so they do not interfere with the mounting surfaces of the
wheel. Installing wheels without correct metal-to-metal contact
at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel
to come off while your vehicle is in motion, resulting in
loss of vehicle control, personal injury or death.
* Torque specifications are for nut and bolt threads free of dirt and rust.
Use only our recommended replacement fasteners.
Retighten the lug nuts to the specified torque within 100 mi (160 km) after
any wheel disturbance (such as tire rotation, changing a flat tire,
wheel removal).
- Wheel pilot bore
Inspect the wheel pilot bore and mounting
surface prior to installation. Remove any
visible corrosion or loose particles.
WARNING: The jack supplied with
this vehicle is only intended for changing
wheels. Do not use the vehicle jack other
than when you are changing a wheel in an
emergency...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
LH (left-hand) shown, RH (right-hand) similar.
Remove the Loadspace trim panel.
Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
BCMC
U0100:87
Lost Communication With ECM/PCM "A": Missing Message
GO to Pinpoint Test A
BCMC
U0111:87
Lost Communication With Battery Energy Control Module "A": Missing Message
GO to Pinpoint Test B
BCMC
U0140:87
Lost Communication With Body Control Module: Missing Message
GO to Pinpoint Test C
BCMC
U0164:87
Lost Communication With HVAC Control Module: Missing Message
GO to Pinpoint Test D
BCMC
U024D:87
Lost Communication With "Seat Control Module J": Missing Message
GO to Pinpoint Test E
BCMC
U0293:87
Lost Communication With Hybrid/EV Powertrain Control Module: Missing Message
GO to Pinpoint Test F
BCMC
U1000:00
Solid State Driver Protection Active: Driver Disabled: No Sub Type Information
GO to Pinpoint Test G
BCMC
U2100:00
Initial Configuration Not Complete: No Sub Type Information
GO to Pinpoint Test H
BCMC
U2200:00
Control Module Configuration Memory Corrupt: No Sub Type Information
GO to Pinpoint Test H
BCMC
U3000:49
Control Module: Internal Electronic Failure
GO to Pinpoint Test I
BCMC
U3003:16
Battery Voltage: Circuit Voltage Below Threshold
GO to Pinpoint Test J
BCMC
U3003:17
Battery Voltage: Circuit Voltage Above Threshold
GO to Pinpoint Test K
Pinpoint Tests
PINPOINT TEST A : U0100:87
Refer to Wiring Diagrams Cell 14 for schematic and connector information...