Lincoln Aviator: Wipers and Washers / Windshield Wipers - Vehicles Without: Heated Wiper Blades
Push the lever up or down to
operate the windshield wiper.
- Single wipe.
- Intermittent wipe.
- Normal wipe.
- High-speed wipe.
Note: Fully defrost the windshield before you switch the windshield wipers on.
Note: Make sure that you switch the windshield wipers off before entering a car wash.
Note: If streaks or smears appear on the windshield, clean the windshield and the wiper blades. If that does not resolve the issue, install new wiper blades.
Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage the wiper blades or cause the wiper motor to burn out. Always use the windshield washers before wiping a dry windshield.
Intermittent Wipe
- Intermittent wipe.
- Shortest wipe interval.
- Longest wipe interval.
Use the rotary control to adjust the intermittent wipe interval.
Speed Dependent Wipers
When your vehicle speed increases, the interval between wipes decreases.
Windshield Wipers - Vehicles With: Heated Wiper Blades. Autowipers
Windshield Wipers - Vehicles With: Heated Wiper Blades
Heated Wiper Blade
The heated wiper blades turn on in low
temperature when the windshield wipers are
active or defrost is on...
Other information:
Lincoln Aviator 2020-2024 Service Manual: Diagnosis and Testing - Perimeter Anti-Theft Alarm
Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Diagnostic Trouble Code Chart Module DTC Description Action BCM B109F:01 Intrusion Sensor Module: General Electrical Failure GO to Pinpoint Test B BCM B109F:02 Intrusion Sensor Module: General Signal Failure GO to Pinpoint Test B BCM B109F:08 Intrusion Sensor Module: Bus Signal / Message Failure GO to Pinpoint Test B BCM B109F:49 Intrusion Sensor Module: Internal Electric Failure GO to Pinpoint Test E BCM B109F:55 Intrusion Sensor Module: Not Configured GO to Pinpoint Test F BCM B109F:97 Intrusion Sensor Module: Component or System Operation Obstructed or Blocked GO to Pinpoint Test B BCM B109F:9A Intrusion Sensor Module: Component or System Operating Conditions GO to Pinpoint Test B BCM B1305:01 Hood Switch: General Electrical Failure GO to Pinpoint Test D BCM B1305:11 Hood Switch: Circuit Short To Ground GO to Pinpoint Test D BCM B1305:15 Hood Switch: Circuit Short To Battery or Open GO to Pinpoint Test D Symptom Chart Symptom Chart: Anti-Theft - Perimeter Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Lincoln Aviator 2020-2024 Service Manual: General Procedures - Tire Pressure Monitoring System (TPMS) Sensor Location Calibration
Special Tool(s) / General Equipment 204-D081A (204-D081) Tire Pressure Monitor (TPMS) Ford Diagnostic Equipment Programming NOTE: The TPMS can be placed into learn mode using a diagnostic scan tool or manually where a diagnostic scan tool is not available...
Categories
- Manuals Home
- Lincoln Aviator Owners Manual
- Lincoln Aviator Service Manual
- Body and Paint
- Disabling Auto-Start-Stop
- Remove and Reinstall the Battery
- New on site
- Most important about car
Remote Control
Passive Key
The passive key operates the power locks and the remote start system. The passive key must be in your vehicle to use the push button start.
Note: You may not be able to shift out of park (P) unless the passive key is inside your vehicle.
