Lincoln Aviator: Load Carrying / Roof Racks and Load Carriers
WARNING: When loading the roof
racks, we recommend you evenly distribute
the load, as well as maintain a low center
of gravity. Loaded vehicles, with higher
centers of gravity, may handle differently
than unloaded vehicles. Take extra
precautions, such as slower speeds and
increased stopping distance, when driving
a heavily loaded vehicle.
For correct roof rack system function, you
must place loads directly on crossbars affixed
to the roof rack side rails. When using the
roof rack system, we recommend you use
Ford Genuine Accessory crossbars designed
specifically for your vehicle.
Make sure that you securely fasten the load.
Check the tightness of the load before
driving and at each fuel stop.
Note: Never place loads directly on the roof
panel. The roof panel is not designed to
directly carry a load.
Maximum Recommended Load Amounts (If Equipped)
Note: The maximum recommended load is
based on the load being evenly distributed
on the crossbars.
WARNING: Make sure that the posts
are properly latched in mounting features.
The cover may cause injury in a sudden
stop or accident if it is not securely
installed...
Vehicle Loading - with and without a Trailer
This section guides you in the proper
loading of your vehicle, trailer, or both.
Keep your loaded vehicle weight within
its design rating capability, with or
without a trailer...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
ABS
B1111:4B
Electric Park Brake Enable:Over Temperature
GO to Pinpoint Test F
ABS
B1111:53
Electric Park Brake Enable:Deactivated
GO to Pinpoint Test G
ABS
B1111:54
Electric Park Brake Enable:Missing Calibration
GO to Pinpoint Test E
ABS
C0609:01
Park Brake Switch Circuit:General Electrical Failure
GO to Pinpoint Test B
ABS
C0616:9A
Park Brake Control Module Control Circuit Performance:Component or System Operating Conditions
GO to Pinpoint Test B
ABS
C1034:01
Park Brake:General Electrical Failure
GO to Pinpoint Test B
ABS
C1034:07
Park Brake:Mechanical Failures
GO to Pinpoint Test K
ABS
C1034:13
Park Brake:Circuit Open
GO to Pinpoint Test B
ABS
C1034:25
Park Brake:Signal Shape/Waveform Failure
GO to Pinpoint Test B
ABS
C1034:2F
Park Brake:Signal Erratic
GO to Pinpoint Test B
ABS
C1034:47
Park Brake:Watchdog/Safety µC Failure
GO to Pinpoint Test B
ABS
C1034:48
Park Brake:Supervision Software Failure
GO to Pinpoint Test B
ABS
C1034:57
Park Brake:Invalid/Incompatible Software Component
GO to Pinpoint Test B
ABS
C1034:71
Park Brake:Actuator Stuck
GO to Pinpoint Test C
ABS
C1034:77
Park Brake:Commanded Position Not Reachable
GO to Pinpoint Test C
ABS
C1034:78
Park Brake:Alignment Or Adjustment Incorrect
GO to Pinpoint Test H
ABS
C1034:97
Park Brake:Component or System Operation Obstructed or Blocked
GO to Pinpoint Test D
ABS
C1A43:98
Motor Supply:Component or System Over Temperature
GO to Pinpoint Test D
ABS
C2005:18
Right Actuator:Circuit Current Below Threshold
GO to Pinpoint Test D
ABS
C2005:19
Right Actuator:Circuit Current Above Threshold
GO to Pinpoint Test D
ABS
C2005:77
Right Actuator:Commanded Position Not Reachable
GO to Pinpoint Test C
ABS
C2005:78
Right Actuator:Alignment Or Adjustment Incorrect
GO to Pinpoint Test A
ABS
C2006:18
Left Actuator:Circuit Current Below Threshold
GO to Pinpoint Test D
ABS
C2006:19
Left Actuator:Circuit Current Above Threshold
GO to Pinpoint Test D
ABS
C2006:77
Left Actuator:Commanded Position Not Reachable
GO to Pinpoint Test C
ABS
C2006:78
Left Actuator:Alignment Or Adjustment Incorrect
GO to Pinpoint Test A
ABS
C2007:13
Right Motor:Circuit Open
GO to Pinpoint Test D
ABS
C2007:1C
Right Motor:Circuit Voltage Out Of Range
GO to Pinpoint Test D
ABS
C2007:92
Right Motor:Performance Or Incorrect Operation
GO to Pinpoint Test D
ABS
C2008:13
Left Motor:Circuit Open
GO to Pinpoint Test D
ABS
C2008:1C
Left Motor:Circuit Voltage Out Of Range
GO to Pinpoint Test D
ABS
C2008:92
Left Motor:Performance Or Incorrect Operation
GO to Pinpoint Test D
ABS
U2002:00
Switch:No Sub Type Information
GO to Pinpoint Test J
ABS
U2002:47
Switch:Watchdog/Safety µC Failure
GO to Pinpoint Test B
Symptom Chart(s)
Symptom Chart: Parking Brake and Actuation
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
Make sure the steering wheel and the road wheels are in the straight ahead position.
NOTE:
Vehicle with heated steering wheel shown others similar.
NOTE:
This step is only necessary when installing a new component...