Lincoln Aviator: Vehicle Care

Changing the Rear Wiper Blades

You can improve poor wiper quality by cleaning the wiper blades and the windshield. Replace the wiper blades at least annually for optimum performance...

Cleaning Products

Materials For best results, use the following products or products of equivalent quality: For additional information and assistance, we recommend that you contact an authorized dealer...

Other information:

Lincoln Aviator 2020-2024 Service Manual: Diagnosis and Testing - Starting System - 3.0L EcoBoost

Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices.REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).   Diagnostic Trouble Code Chart Module   DTC Description Action   BCM C113A:11 Wakeup Control: Circuit Short To Ground   GO to Pinpoint Test E   BCM C113A:15 Wakeup Control: Circuit Short To Battery Or Open   GO to Pinpoint Test E   PCM P06E4:00 Control Module Wake-up Circuit Performance: No Sub Type Information   GO to Pinpoint Test A   PCM P06E9:00 Engine Starter Performance: No Sub Type Information   GO to Pinpoint Test B   PCM P06E9:00 Engine Starter Performance: No Sub Type Information   GO to Pinpoint Test C   PCM P162F:00 Starter Motor Disabled - Engine Crank Time Too Long: No Sub Type Information   GO to Pinpoint Test H   PCM P2535:00 Ignition Switch On/Start Position Circuit High: No Sub Type Information   GO to Pinpoint Test F   PCM P2535:00 Ignition Switch On/Start Position Circuit High: No Sub Type Information   GO to Pinpoint Test G Inspection and Verification Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

Lincoln Aviator 2020-2024 Service Manual: Removal and Installation - Rear Audio Control Module (RACM)

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: Touchscreen controls shown, analog controls are similar. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module...