Lincoln Aviator: Cruise Control / Canceling and Resuming the Set Speed
Canceling
Press the button, or tap the
brake
pedal to cancel the set speed.
Note: The system remembers the set speed.
Note: The system cancels if the vehicle
speed drops below 10 mph (16 km/h) under
the set speed when driving uphill.
Resuming
Press the button.
Cruise Control Indicators
Illuminates when you switch the
system on.
WARNING: When you are going
downhill, your vehicle speed could
increase above the set speed. The system
does not apply the brakes.
Drive to the speed you prefer...
Other information:
Diagnostic Trouble Code (DTC) Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).
Diagnostic Trouble Code Chart
Module
DTC
Description
Action
PACM
B1A01:01
Speaker #1: General Electrical Failure
GO to Pinpoint Test C
PACM
B1A01:11
Speaker #1: Circuit Short To Ground
GO to Pinpoint Test C
PACM
B1A01:12
Speaker #1: Circuit Short To Battery
GO to Pinpoint Test D
PACM
B1A01:13
Speaker #1: Circuit Open
GO to Pinpoint Test D
PACM
B1A02:01
Speaker #2: General Electrical Failure
GO to Pinpoint Test C
PACM
B1A02:11
Speaker #2: Circuit Short To Ground
GO to Pinpoint Test C
PACM
B1A02:12
Speaker #2: Circuit Short To Battery
GO to Pinpoint Test D
PACM
B1A02:13
Speaker #2: Circuit Open
GO to Pinpoint Test D
PACM
U0100:00
Lost Communication With ECM/PCM "A": No Sub Type Information
GO to Pinpoint Test E
PACM
U0140:00
Lost Communication With Body Control Module: No Sub Type Information
GO to Pinpoint Test F
PACM
U0422:00
Invalid Data Received From Body Control Module: No Sub Type Information
GO to Pinpoint Test G
PACM
U201A:51
Control Module Main Calibration Data: Not Programmed
GO to Pinpoint Test H
PACM
U2101:00
Control Module Configuration Incompatible: No Sub Type Information
GO to Pinpoint Test H
PACM
U3000:41
Control Module: General Checksum Failure
GO to Pinpoint Test I
PACM
U3000:42
Control Module: General Memory Failure
GO to Pinpoint Test I
PACM
U3000:96
Control Module: Component Internal Failure
GO to Pinpoint Test I
PACM
U3003:16
Battery Voltage: Circuit Voltage Below Threshold
GO to Pinpoint Test J
PACM
U3003:17
Battery Voltage: Circuit Voltage Above Threshold
GO to Pinpoint Test K
Symptom Chart
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...
Removal
NOTICE:
Under no circumstances should the accessory drive belt,
tensioner or pulleys be lubricated as potential damage to the belt
material and tensioner damping mechanism will occur. Do not apply any
fluids or belt dressing to the accessory drive belt or pulleys...